Timms Trap and Sound Lure Success

 

As noted previously we have started to experiment specifically with HD video and the sound lure to determine what specifically brush tailed possums might be reacting to with the sounds from the sound lure.

It has been suggested that the sound lure, while designed to attract pest animals to the site of traditional traps could be instead acting as a deterrent to cause animals to avoid the location.  For the previous week and a half we have been deploying a HD Camera to help us answer this question and using a basic analysis of the video to note the response of the animals when the unit activates.   During this time we have seen clear evidence of multiple visits to the site during the evening by a number of brush tailed possum.   There has been a mother and a baby and at least two distinct males returning to the site.   The unit has played repeatedly during this time and there have been up to eight activations in a night.   

Previously we have not focussed on attempting to trap any possums at this location - we have simply been trying to determine if we can answer the question and test or note their reaction to the sound being activated (as noted it is on a one minute delay).   The sound lure was previously located inside of the DOC200 (see picture) however we for the first time switched it to placing it inside a Timms possum trap.   We used an electric drill to make an opening in the back of the Timms, which the speaker was directly attached to unit - this had the effect of acting to amplify the sound considerably.

Rather frustratingly the trap work perfectly.   The frustrating part of this was that the camera that was monitoring the unit did not.  We made a capture at the location of a significant male (buck) possum.

There was additional evidence of a further possum attack - which we have repeatedly seen, where a dead possum has been attacked by a second possum as there was ripped fur around the capture, again this frustratingly was not recorded as the camera was not able to record it.   

Once again I feel compelled to point out that this is a single location where we are merely testing our equipment to get it to the point that we can be confident that it is operating as we intended.   We would like to make the technology and the experience that we have had available for wider use and the data and information likewise.

Back to the original question that we are currently focussed on answering.   We have had multiple activations at our site over an increasing period of time.  We have had some limited evidence of possums leaving the site when the unit activates, however in every case we can then see them return and we are having multiple visits during the course of an evening.  

Obviously we have to look at our capture rate with the Timms trap, but one would suggest the fact that a capture was made, and at least one additional possum was present (as evidenced by the fur from the first possum) and again this would suggest that the lure is not acting as a deterrent.

Moving forward we will continue to monitor the site and look at adjust the camera footage recording so that it operates successfully.  We are not going to simply upload hours of footage that we already have showing the lure/possum interactions as we have already done with some parts, however that is available on request.